BLOG     |     FORUM
Welcome, Guest
Username: Password: Remember me
Get quick Unbrowse SNMP help from Unleash Networks Engineers. The fastest way.
  • Page:
  • 1

TOPIC: Compiling private MIB requires closing program

Compiling private MIB requires closing program 12 years 9 months ago #509

I am developing a private MIB and using the program to COMPILE in strict mode to find all of my errors. When I make a change to the MIB file within the program, or externally, and I compile the MIB, it appears as if the new saved MIB is not used in the compile, event though the edits are saved to the MIB file.
If I close the program and restart, it compiles the file as seen on the hard drive.
So every time I make an EDIT on the MIB to recompile and check my syntax, I need to close the program and re-open the program to get it to correctly compile.
It is as if it has a CACHED version of the MIB that it will not give up until shutdown.
This is very tedious, am I doing something completely stupid when I COMPILE or ADD MIB?
The administrator has disabled public write access.

Re:Compiling private MIB requires closing program 12 years 9 months ago #510

Try this :

1. Edit the MIB file within Unbrowse

2. While the editor is still open - press F7 to compile & load

3. Make some more changes - and save it of course (Ctrl+S)

4. Press F7 again

repeat repeat
Vivek R
Unleash Networks
Support : www.unleashnetworks.com/forums
The administrator has disabled public write access.
  • Page:
  • 1
Moderators: vivek [unleash]
Time to create page: 0.035 seconds